Gaskets with flat design
Rubber-steel gaskets with flat design
The G-ST/FD is a version of our proven G-ST in a thinner design. With a thickness of 3 mm, this gasket is particularly suitable as a repair gasket for very rigid piping systems.
For the installation of a gasket, a certain gap dimension must be available between the flange leaves into which the gasket can be inserted. In some cases, especially with large diameters, this is not always wide enough. The flat design of the G-ST provides a remedy at this point.
Your advantages when using gaskets with flat design
Particularly flat design as repair gasket
Tightness even at low surface pressure (even at low tightening torques)
Very good adaptability to the gasket surfaces
Low leakage rates thanks to homogeneous structure of elastomeric materials
Blow-out safety and maximum stability due to centrally positioned, corrosion-protected and vulcanized steel inlay
Technical informationen
Dimensions
DN 80, 100, 150, 200, other dimensions on request
Materials
NBR-DUO-EL, EPDM-EL, EPDM, CSM, HNBR, IIR, FKM, CR, NR
Standards
DIN EN 1514-1 (casting dimension)
Download catalog
You will find the complete range of rubber-steel gaskets in our product catalog.
Please contact us
Kroll & Ziller Germany
Reisholzstrasse 15
D-40721 Hilden
P.O. Box 970
Sales export
Phone .: 0049 (0) 2103 / 951- 0
Fax: 0049 (0) 2103 / 951-510
Email: info@kroll-ziller.de
Domestic sales
Phone .: 0049 (0) 2103 / 951- 0
Fax: 0049 (0) 2103 / 951-508 / 509
Email: info@kroll-ziller.de